Features:

•  208-230 VAC = 1-30 HP (.75kw - 22Kw)
• 385-415 VAC = 1-75 HP (.75Kw - 55Kw)
• 480 VAC = 1-100 HP (.75Kw - 74.5Kw)
• 575 VAC = 1-75 HP (.75Kw - 55.9Kw)
• All drives contain dynamic braking circuitry internal up through 100 hp.
• Every unit up to 5 HP has Regeneration Resistors and dynamic braking already built in.
• High quality faceplate and side panels covering the electronics for high reliability and safety.
• Gang-Set™ Programming - Easy instant programming.
• 1, 2, 3, 4 or 5 speeds including Vari-Easy-Speed 2 and Vari-Easy-Speed 3 infinitely variable modes. Each speed may be individually reset to your needs
• Potentiometer ready for "fingertip" precision.
• Left and Right limit switch inputs (also programmable functions).
• Variabld speed A.C. output
• Three phase A.C. input
• Thermal overload input trips shown on the display.
• Charge light
• Brake contactor control
• N/O or N/C relay for signaling
• Integral control signal interface with on-board 115VAC (or other) control signal inputs -- (no unreliable control voltage input boards required).
• Large Display! Tall LED anti-glare display can be seen from a distance. Display frequency and 38 crane specific adjustment parameters (if needed).
• Hardware is robust to withstand high vibration of overhead cranes.

Crane Diagnostics:

• Checks control signals
• Check pendant station
• Checks load brake wear
• Check brakes
• Stores faults
• Trip messages

(A) Size

The designation [ ] are past sizes. The designation ( ) are approximate future sizes. The size in bold are the sizes available as of the printing of this brochure. The other physical sizes are in order of introduction. The reduced size models may be available without notice. SEE UPGRADE PATH PHILOSOPHY INFORMATION.

(B) Regen Circuitry Included

Unique to PE is that all drives include the regeneration electronic transistor circuitry as standard and is not needed to be purchased separately. The EXTERNAL regen resistors are purchased separately.

(C) Regen Resistor

Horizontal motion control applications for bridge/trolley monorail etc., will require an external regen resistor banks (sold separately by PE) unless it is noted as being INTERNAL to the drive. PE external resistor's are designed with special electrical safety housings. Un-enclosed resistor's (such as those used for reduced voltage starting applications) are dangerous and not safe for use with any variable speed drive and should never be used. Unlike generic drives, PE has designed into its drive's the electronic portion of the regeneration circuitry. Most Weston Load Brake style hoists do NOT require regen resistors with PE drives (unique PE feature). PE discourages the use of external regen resistors on load brake hoists. Many worm gear hoists, with PE drives, may not require regen resistor ballasts either.

(D) Control Signal Interface

PE Drives are designed for overhead crane applications and they do not require separate interface cards. The control signal interface is built into the drive (not a separate add-on card or parts to loosen). 115vac is standard, all other voltages are available, including 24vac and 48vac or dc.

(E) Starting Torque

PE drives have the highest starting torque of any drive in the industry of 300%. Most generic drives are only 180% or less.

*No drill mounting brackets - quickly modernize older PE drives to newer!

fig.2 b size drive with TACX